LoopBe1 is a virtual MIDI device for transferring MIDI data between computer programs. Basically LoopBe1 is an "invisible cable" to connect a MIDI outport of an application to any other application's MIDI inport. All MIDI data sent to the program's output is channeled to the receiving applications in realtime. You may connect up to 8 applications to LoopBe's inport and up to 8 applications to the outport, all sending and receiving at the same time. LoopBe1 is a native Windows 2k/XP WDM kernel mode driver, so expect the lowest possible latency. Programs do not need to link with special libraries, so LoopBe1 works with every MIDI or DirectMusic capable application. LoopBe1 comes with a Systray Icon. You can switch it on and off like a hardware device and view its status. LoopBe1 has a powerful shortcut detection to avoid MIDI feedback. If a feedback is detected, LoopBe1 will immediately mute its port, interrupt the loop and popup a message. After disabling the malicious MIDI through within your program you can easily enable LoopBe1 again at its systray icon. LoopBe1 is free for non-commercial, personal use only. Any commercial use beyond a 30-day evaluation period requires purchase of a commercial use license. LoopBe1 is licensed as freeware, full size of the download is 0.97 MB. You can download a free copy of LoopBe1 by following download link at Free Downloads section of this page. LoopBe1 is developed or distributed by nerds.de and is listed under audio & multimedia other.
